Six Principle To Find A Proper Injection Mold Factory
If you want to make plastic parts or develop some product and looking for some injection mold factory, there are six principles as below
Principle I: reliable team and good attitude
the mold factory should have rich experience engineer and teamwork., the team is equipped to fly. When you find a mold factory, you can not allow manufacturers to ignore you, probably injection mold china because too many orders start at the same time, probably because they didn’t pay attention to detail and so on, so to make a phone call in two days or three days a week, take a look. To maintain a relationship with them.
Principle II: The ability to describing a good prospect
Tell him your project have a good future, rather than ask him to help you do that. Let him know that
you give the best products to him, but also it is his chance. In fact, in the final analysis, it is to your china molding supplier but also as one of your investors, so that they have an idea with your success. Share with your mold factory your understanding of the industry, From the boss to toolmakers, should be enough respected.
Principle III: ID-MD, mold making and injection molding in one-stop
Industrial design and structural design are done in one factory, although there may be some small problems, the advantages in one factory should be bigger. Mold making and injection molding should be done the same
Principle IV: Not the best, but the proper
Not the biggest and best mold factory is suitable for you, nor is it a small mold factory is simply not considered. Select mold factory, depending on your project, precision, development cycle and costs. Precision and cycle always conflict with the cost. Here you have a balance. Also not a small mold factory, we can help you save money. Small mold factories will often respond quickly. But where there injection mould companies will be a lot of such irregularities problem.
Principle V: The standard is the key
To avoid unnecessary fighting and possible miscommunications. You should record every design change, all drawing, spec and reports should be written in paper and signed
Principle VI: patent application or NDA
Normally you should sign an NDA or Patent application before you make molds, it will protect your product not to be copied.
According to the market of both companies, find the supplier that suits oneself. What kind of supplier does the company want to find? What is the most important